LR3/Disco 3
Air Suspension Pressure Sensor
Removal
Installation
1 .
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the
vehicle on safety stands.
Raise and support the vehicle.
2 .
Remove the air compressor housing cover.
Remove the 3 bolts.
Release the 5 clips.
3 .
Using T4, depressurize the air suspension. For additional information, refer to
Air Suspension
System Depressurize and Pressurize (60.50.38)
(Section 204-05)
4 .
NOTE:
Make sure the valve block does not become detached during removal of the air pressure sensor.
Disconnect the electrical connector.
5 .
CAUTION: Before the disconnection or removal of any components, ensure the area around
joint faces and connections are clean. Plug any open connections to prevent contamination.
Remove the air pressure sensor.
Remove and discard the O-ring seal.