LR3/Disco 3
1 .
NOTE:
Make sure the valve block does not become detached during installation of the air pressure sensor.
Install the air pressure sensor.
Install a new O-ring seal.
Tighten to 5 Nm (4 lb.ft).
2 .
Connect the electrical connector.
3 .
Using T4, pressurize the air suspension. For additional information, refer to
Air Suspension System
Depressurize and Pressurize (60.50.38)
(Section 204-05)
4 .
CAUTION: Make sure the air suspension compressor upper cover is correctly positioned.
CAUTION: Make sure the air suspension exhaust pipe is correctly located in to the air
suspension upper cover.
Install the air compressor housing cover.
Install the bolts and tighten to 9 Nm (7 lb.ft).