LR3/Disco 3
Installation
10 .
Install the shock absorber and air spring assembly.
Make sure the shock absorber and air spring assembly top mounting to body mating
faces are clean.
Connect the air line into the Voss connector.
Pull on the air line to make sure it is fully installed into the Voss connecter.
Fit the nuts and tighten to 63 Nm (46 lb.ft).
1 .
CAUTION: Make sure the new Voss connector is installed and fully tightened with the
alignment plug installed.
Install a new Voss connector to the air spring.
Tighten to 3.5 Nm (2.6 lb.ft)
2 .
Install the shock absorber and air spring assembly.
Make sure the shock absorber and air spring assembly top mounting to body mating faces
are clean.
Fit the nuts and tighten to 63 Nm (46 lb.ft).
Connect the air line into the Voss connector.
Pull on the air line to make sure it is fully installed into the Voss connecter.
3 .
Connect the shock absorber and air spring assembly to the lower arm.
Tighten the nut and bolt to 300 Nm (221 lb.ft).
4 .
Using T4, pressurize the air suspension. For additional information, refer to
Air Suspension System
Depressurize and Pressurize (60.50.38)
(Section 204-05)
5 .
Install the wheel and tire.
Tighten the wheel nuts to 140 Nm (103 lb.ft).