Range Rover P38
PANEL REPAIRS
11
REPAIR
REAR QUARTER REPAIR PANEL
Remove
1. Disconnect both battery leads, negative lead
first.
2. Raise rear of vehicle.
WARNING: Support on safety stands.
3. Disconnect all ECUs.
4. Disconnect airbags and sensor system.
5. Disconnect alternator.
6. Remove tailgate - lower.
See CHASSIS AND
BODY, Repair.
7. Remove tailgate - upper.
See CHASSIS AND
BODY, Repair.
8. Remove parcel tray support and trim.
See
CHASSIS AND BODY, Repair.
9. Remove ’E’ post - exterior trim.
See CHASSIS
AND BODY, Repair.
10. Remove ’D’ and ’E’ post trims.
See CHASSIS
AND BODY, Repair.
11. Remove wheel arch liner - rear.
See CHASSIS
AND BODY, Repair.
12. Remove rear quarterlight.
See CHASSIS AND
BODY, Repair.
13. Remove rear quarter rubbing strip.
See
CHASSIS AND BODY, Repair.
14. Remove rear bumper valance.
See CHASSIS
AND BODY, Repair.
15. Remove rear seat belt - left hand or right hand.
See CHASSIS AND BODY, Repair.
16. Remove sunroof drain tube - rear.
See
CHASSIS AND BODY, Repair.
Refit
NOTE: In this operation, the rear quarter
repair panel, outer quarter and rear quarter
repair panel are replaced in combination.
17. Cut new rear quarter repair panel to form MIG
welded butt joints with existing panels.
CAUTION: Do NOT cut into the inner
quarter during this operation.
18. Reverse removal procedure.
19. Remove stands and lower vehicle.