Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual23 · Rear and Side Rail
23 · General

Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual
Rear and Side RailRear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Rear and Side Rail

18-4

REAR AND SIDE RAIL

TOP STACK ADJUSTMENT

TOP DOWN STOP

lf “down stop” is too HIGH, top boot will not fit over top stack assembly. If “down stop” is too LOW, rapid top cover degradation will occur.

1.

LOWER TOP TO FULL DOWN POSITION.

Handle - clamp assembly ~

2.

MEASURE DISTANCE BETWEEN LOWEST EDGE OF

RELEASE HANDLES AND SEAT BELT “D” RINGS, BOTH

ZL, { SIDES.

Belt webbing - Ss rearseat ae

4imm + 6mm

Open release handle and position handle over “D” ring.

retractor Specification: 41mm +/- 6mm

/NX Rear seat back

3.

ADJUST TOP DOWN STOP.

(a) Raise top enough to access down stop block screw. (b) Loosen screw and turn “eccentric” block as required. (c) Tighten down stop block screw. Torque: 17 Nm (13 ft. Ib.)

4.

CHECK TOP DOWN HEIGHT.

(a) Cycle top up and down two (2) times. (b) Repeat step 1 and step 2 if necessary.

TOP UPSTOP

Right and left side up stops must be adjusted evenly to prevent No. 1 bow-to-header misalignment.

1.

LOWER AND RAISE TOP, DO NOT LATCH TOP TO

WINDSHIELD HEADER.

np

2.

MEASURE DISTANCE BETWEEN TOP OF WINDSHIELD

{23mm + 2mm

HEADER SEAL AND SEALING SURFACE OF NO. 1 BOW.

(.93 in.) No. 1 bow Specification: 23mm +/- 2mm — Front header ae

3.

ADJUST TOP UPSTOP.

weatherstrip _/ (a) Raise top enough to move rear rail off top upstop.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.