Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual23 · Rear and Side Rail
23 · General

Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual
Rear and Side RailRear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Rear and Side Rail

REAR AND SIDE RAIL

18-9

REAR RAIL AND MAIN PIVOT (cont'd)

3.

REMOVE REAR RAIL PIVOT BOLT BUSHINGS.

Using a punch, remove two (2) bushings from rear rail.

ASSEMBLE

1.

INSTALL REAR RAIL PIVOT BOLT BUSHINGS.

Gently tap two (2) bushings into rear rail.

2.

INSTALL DOWN STOP ECCENTRIC BLOCK.

(a) Position eccentric block to rear rail in same position as when removed. (b) Install down stop screw. Do not torque screw at this time.

3.

INSTALL SEAL CARRIER TO REAR RAIL.

(a) Apply general purpose lubricant to rear rail slot. (b) Apply Loctite (P/N 271 or equivalent) to bolt threads and secure seal carrier to rear rail using two (2) bolts. Torque: 6 Nm (53 in. Ib.)

(Cc). Connect spring to seal carrier and rear rail.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.