Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual23 · Rear and Side Rail
23 · General

Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual
Rear and Side RailRear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Rear and Side Rail

REAR AND SIDE RAIL

18-16 SIDE RAIL ASSEMBLY (cont'd)

INSTALL HEADLINER ASSEMBLY TO DRAIN TROUGH.

6. Install headliner rear strap to drain trough with screw.

INSTALL TOP COVER TO NO. 1 BOW (see 11-9).

ADJUST SIDE RAIL ASSEMBLY (see Top Stack Adjustment in

this chapter).

LOWER AND RAISE TOP TWICE AND CHECK TOP STACK

OPERATION. Top stack operation should be smooth and constent. (a) Check door and quarter window to side rail (b) weatherstrip alignment.

NO. 2 BOW BUMPER

REMOVE

LOWER CONVERTIBLE TOP HALFWAY.

1.

REMOVE NO. 2 BOW BUMPER.

2.

Using a drill with a 1/8 in. bit, remove bumper rivet and bumper

from side rail. INSTALL

2 BOW BUMPER.

INSTALL NO.

1.

Position bumper with a suitable washer to side rail and secu i

using one (1) 1/8 x .375 rivet.

RAISE AND LATCH CONVERTIBLE TOP AND CHECK

BUMPER INSTALLATION.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.