Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual23 · Rear and Side Rail
23 · General

Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual
Rear and Side RailRear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Rear and Side Rail

REAR AND SIDE RAIL

18-12

REAR RAIL AND MAIN PIVOT (cont'd)

INSTALL NO. 3 BOW TO REAR RAIL.

8. Position bow and center link assembly to rear rail. (a) Apply Loctite (P/N 271 or equivalent) to bolt threads (b) and install bolt, both sides. Torque: 17 N.m (13 ft. tb.) Position top cover and retainer to No. 3 bow and install (c) three (3) screws.

INSTALL NO. 4 BOW TO REAR RAIL ASSEMBLY.

9. Fold top cover, backlite and No. 4 bow rearward (a) positioning bow to rear rail. Apply Loctite (P/N 271 or equivalent) to bolt threads (b) and secure No. 4 bow to rear rail with one (1) bolt and (2) bushings, each side. Torque: 17 Nm (13 ft. Ib.)

INSTALL TOP COVER WITH TACK STRIP TO DRAIN

10.

TROUGH AND TOP COVER TO RIGHT AND LEFT SEAL

CARRIERS (see 11-7).

INSTALL REAR SPEAKER ASSEMBLY IF REMOVED.

11. Connect speaker electrical connector. (a) Position speaker to body panel and secure using four (b) (4) screws. INSTALL QUARTER TRIM PANEL (see 5-5).

12.

43. ADJUST TOP UP AND DOWN STOPS (see Top Stack

Adjustment in this chapter). INSTALL HEADLINER ASSEMBLY (see 10-4).

14.

SIDE RAIL ASSEMBLY

REMOVE

REMOVE TOP COVER FROM NO. 1 BOW, (see 11-3).

{. |

REMOVE SCREW ATTACHING HEADLINER TO DRAIN

2. : TROUGH.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.