Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual
Rear and Side Rail
18-6
REAR AND SIDE RAIL
TOP STACK ADJUSTMENT (cont'd)
Rotate adjustment screw as required to adjust side rail (b) assembly parallel with door glass upper edge.
CHECK FRONT TO CENTER RAIL ALIGNMENT.
5. (a) Cycle top up and down two (2) times then latch top to header. (b) Check that side rail weatherstrip is parallel to top edge of door glass while maintaining a satisfactory seal.
REAR RAIL AND MAIN PIVOT
REMOVE
NOTE: Tape a protective cover to belt moldings, trun lid, quarter panels and both sides of the backlite.
1. REMOVE HEADLINER ASSEMBLY (see 10-3).
2. REMOVE QUARTER TRIM PANELS (see 5-3).
REMOVE REAR SPEAKER ASSEMBLY.
3.
NOTE: Remove speaker ONLY if main pivot bracket i: to be removed. (a) Remove four (4) screws securing speaker to body panel. (b) Disconnect speaker electrical connector and remove speaker.
4.
REMOVE TOP COVER FROM RIGHT AND LEFT SEAL
CARRIERS AND TOP COVER TACK STRIP FROM DRAIN
TROUGH (see 11-3).
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.