Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual23 · Rear and Side Rail
23 · General

Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Rear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual
Rear and Side RailRear and Side Rail - Nissan 240SX 1991-1992 Workshop Manual

Rear and Side Rail

18-10

REAR AND SIDE RAIL

REAR RAIL AND MAIN PIVOT (cont’d)

NOTE: Continue with REMOVAL procedure ONLY if main pivot bracket is to be removed. If main pivot bracket is not removed, go to INSTALL step 3.

12.

REMOVE TWO (2) BOLTS FROM MAIN PIVOT BRACKET

EXTENSION AND REMOVE EXTENSION PLATE.

13.

REMOVE MAIN PIVOT BRACKET ASSEMBLY.

(a) Remove hydraulic cylinder from main pivot bracket pin. (b) Using a pencil, mark pivot bracket to body panel location.

(c) Remove two (2) bolts securing main pivot bracket to body panel and remove main pivot bracket from vehicle.

INSTALL

1.

INSTALL MAIN PIVOT BRACKET ASSEMBLY.

(a) Position main bracket to body panel alignment marks.

NOTE: Four (4) alignment pins (2 per side) are welded to the B-pillar section panel to aid top stack installation. Should the main pivot bracket require replacement, the alignment pins must be removed. (b) Apply Loctite (P/N 271 or equivalent) to bolt threads. Torque: 18 N'm (13 ft. Ib.)

2.

INSTALL MAIN PIVOT EXTENSION AND HYDRAULIC

CYLINDER. (a) Position hydraulic cylinder to main pivot bracket pin. (b) Apply Loctite (P/N 271 or equivalent) to bolt threads and install extension using two (2) bolts. Torque: 22 N'm (16 ft. Ib.)

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.