Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual08 · Weatherstrips and Retainers
08 · General

Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and RetainersWeatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual

Weatherstrips and Retainers

WEATHERSTRIPS AND RETAINERS

3-5

ADJUSTMENT Sealing problems may sometimes be the result of improper operation and/or adjustment of the top stack mechanism. Other components can effect sealing capabilities, such as: door glass or quarter windows and molding adjustments. Some weatherstrip assemblies used on this vehicle are easily adjusted by loosening the retainer fasteners and moving the retainers. Some weatherstrips must be removed from their retainer or a component to be re-positioned, then re-attached. All components must be in place and adjusted correctly for the weatherstrips to function properly. Refer to the respective chapters for adjustment procedures of components directly relating to the weatherstrip. INSPECTING Prior to performing water or air leak tests, it is recommended that a thorough visual inspection be performed. Thoroughly inspect the entire convertible top and all sealing areas for gaps, torn or deteriorated weatherstrips, loose or missing parts, and misaligned components such as window glass.

SEAL TESTING

The Nissan convertible vehicle is designed to operate under normal environmental conditions. It’s sealing capabilities do not take into consideration unnatural conditions such as high pressure car washes. With this in mind, an air or water leak determined to originate from the top stack or its sealing areas can be isolated using the procedures outlined below.

WATER LEAK TEST

The first step in diagnosing a water leak is to determine under what conditions the leak occurs. Once the general area has been determined, localized testing using a water hose or compressed air will isolate the exact entry point. It may be necessary to remove interior panels or moldings to locate leaks or confirm repairs. Always begin testing at the base of the suspected area and slowly continue upward.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.