Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
WEATHERSTRIPS AND RETAINERS
3-13
FRONT RAIL WEATHERSTRIP (cont'd)
(f) Using a flat-bladed tool, install weatherstrip into front rail weatherstrip retainer. (g) Repeat (d) through (f) to install rear half of front rail weatherstrip. (h) Check front rail weatherstrip fit.
FRONT RAIL WEATHERSTRIP RETAINER
REMOVE
NOTE: The front rail weatherstrip and retainer can be removed as an assembly. To do this, release only the front portion of the seal (step 2) enough to reveal attaching screw, then proceed to step 3.
1.
LOWER CONVERTIBLE TOP.
2.
REMOVE FRONT RAIL WEATHERSTRIP.
Using a suitable release agent (3M P/N 051135-08971 or equivalent ) remove weatherstrip from front rail retainer.
3.
MARK FRONT RAIL WEATHERSTRIP RETAINER-TO-FRONT
RAIL LOCATION.
With a pencil, mark location of front rail weatherstrip retainer washers on top side of front rail.
4.
REMOVE FRONT RAIL WEATHERSTRIP RETAINER.
(a) Remove screw at front of retainer.
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.