Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
WEATHERSTRIPS AND RETAINERS
3-19
REAR RAIL WEATHERSTRIP (cont'd) (e) Secure rear rail weatherstrip assembly using three (3) nuts with washers. Torque: 3 Nm (27 in. ib.)
2.
RAISE AND LATCH TOP TO WINDSHIELD HEADER.
RAISE QUARTER WINDOW AND CHECK QUARTER
WINDOW-TO-REAR RAIL WEATHERSTRIP ALIGNMENT (see 6-1).
NOTE: Quarter window-to-weatherstrip alignment can be obtained by adjusting the quarter window guide.
QUARTER WINDOW INNER WEATHERSTRIP
REMOVE
1. _ REMOVE QUARTER TRIM OUTER PANEL (see 5-5).
2.
REMOVE QUARTER WINDOW INNER WEATHERSTRIP.
On a clean work surface, remove staples and inner weatherstrip from outer panel.
INSTALL
1.
INSTALL QUARTER WINDOW INNER WEATHERSTRIP.
(a) Position front edge of weatherstrip to front edge of quarter trim outer panel.
Secure weatherstrip to outer trim panel using four (4) .25 x (b) .31 divergent point staples.
2.
INSTALL QUARTER TRIM OUTER PANEL AND QUARTER
TRIM PANEL (see 5-5).
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.