Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
WEATHERSTRIPS AND RETAINERS
3-11
A-PILLAR WEATHERSTRIP RETAINER
REMOVE
1.
REMOVE RETAINER SECURING WEATHERSTRIP TO TOP
OF A-PILLAR.
REMOVE FRONT HEADER WEATHERSTRIP FROM A-
PILLAR WEATHERSTRIP RETAINER (see Front Header Weatherstrip in this chapter).
CAUTION: If weatherstrip is to be reused, do not tear or damage the weatherstrip during removal. if damaged, weatherstrip must be replaced.
REMOVE A-PILLAR WEATHERSTRIP RETAINER.
Remove four (4) screws, and A-pillar weatherstrip retainer.
CLEAN A-PILLAR WEATHERSTRIP RETAINER.
(a) Remove excess adhesive from front A-pillar weatherstrip retainer. (b) Clean adhesive tape from retainer and header A-pillar.
INSTALL
INSTALL A-PILLAR WEATHERSTRIP RETAINER.
1. (a) If necessary, install new foam tape to retainer. Tape should be installed forward of retainer mounting holes.
(b) Position A-pillar weatherstrip retainer to A-pillar and secure using four (4) screws.
INSTALL FRONT HEADER WEATHERSTRIP TO A-PILLAR
WEATHERSTRIP RETAINER (see Front Header Weatherstrip in this chapter). Ww
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.