Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
WEATHERSTRIPS AND RETAINERS
3-12
INSTALL UPPER A-PILLAR WEATHERSTRIP RETAINER.
3.
FRONT RAIL WEATHERSTRIP
REMOVE
LOWER CONVERTIBLE TOP.
1.
REMOVE FRONT RAIL WEATHERSTRIP.
2. Using a suitable release agent (3M P/N 051135-08971 or equivalent) and a flat-bladed tool, remove weatherstrip from front rail retainer.
CLEAN FRONT RAIL WEATHERSTRIP RETAINER.
3. Remove excess adhesive from front rail weatherstrip retainer.
INSTALL
INSTALL FRONT RAIL WEATHERSTRIP.
1.
Without adhesive, use a flat-bladed tool to install front rail
(a) weatherstrip to retainer. Raise and latch top to header. (b) Position weatherstrip in retainer to achieve all-around (c) satisfactory seal, then lower top.
While holding rear half of weatherstrip in retainer, pull the (d) front half out. Apply a continuous bead of adhesive (3M P/N 051 135- (e) 08008 or equivalent) to exposed portion of retainer.
NOTE: Insure weatherstrip adhesive fills void at center of weatherstrip mounting surface.
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.