Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
WEATHERSTRIPS AND RETAINERS
3-15
FRONT RAIL WEATHERSTRIP RETAINER (cont'd)
TIGHTEN TWO (2) RETAINER NUTS.
4.
Torque: 3 Nm (27 in. Ib.)
TIGHTEN FRONT WEATHERSTRIP RETAINER SCREW.
INSTALL FRONT RAIL WEATHERSTRIP (see Front Rail Weatherstrip in this chapter).
CENTER RAIL WEATHERSTRIP
REMOVE
LOWER CONVERTIBLE TOP HALFWAY.
1.
REMOVE CENTER RAIL WEATHERSTRIP.
2. Using a suitable release agent (8M P/N 051135-08971 or equivalent) and a flat-bladed tool, remove weatherstrip from retainer.
CLEAN CENTER RAIL WEATHERSTRIP RETAINER.
Remove excess adhesive from center rail weatherstrip retainer. ww
INSTALL
INSTALL CENTER RAIL WEATHERSTRIP.
1.
(a) Without adhesive, use a flat-bladed tool to install center rail weatherstrip to retainer. (b) Raise and latch top to header. (c) Position weatherstrip in retainer to achieve all-around satisfactory seal, then lower top.
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.