Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual08 · Weatherstrips and Retainers
08 · General

Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and RetainersWeatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual

Weatherstrips and Retainers

3-6

WEATHERSTRIPS AND RETAINERS

WATER LEAK TEST (cont'd) The use of an assistant inside the vehicle may be helpful.

1. Starting at base of suspected area, apply water using a hose.

2. Water flow should not exceed 22 psi and be unrestricted (no nozzle). Slowly move hose upward over suspected leak area to pinpoint leak. If possible, determine if more than one leak exists in suspected area. Refer to individual component procedures when performing water leak repairs.

AIR PRESSURE TEST

Block-off right and left side pressure relief valves located in

1. luggage compartment behind rear wheelhouse with clean rags and close deck lid.

2. Raise all side windows, latch top to windshield header and close doors.

3. Pressurize vehicle’s passenger/luggage compartment by moving heater control to “VENT” and blower motor to “HIGH” position.

4. Observe suspected area for escaping air by applying a soapy- water solution to area in question.

5. | Watch for air bubbles at suspected leak area. Air bubbles indicate a poor seal.

NOTE: Some air escaping at sides of backlite from under top cover is normal.

6. Refer to individual component procedures when performing water leak repairs.

CHALK TEST

1. Using a suitable household cleaner, clean weatherstrip in question and its mating surface.

2. Carefully apply an un-broken line of powdered chalk or talc to contact surface of the seal in question.

3. Slowly close or mate components pressing weatherstrip firmly against its mating surface.

4. Slowly, separate components and visually inspect weatherstrip RRR and mating surface. If seal is good, chalk line will be distorted and a mirror image will appear on the mating surface. If seal is faulty, chalk line will not distort.

5. Refer to individual component procedures when performing water leak repairs.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.