Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
WEATHERSTRIPS AND RETAINERS
3-20
QUARTER BELT OUTER WEATHERSTRIP
REMOVE REMOVE QUARTER BELT OUTER MOLDING (see 9-4).
1.
REMOVE QUARTER BELT OUTER WEATHERSTRIP.
2. Using a 1/8 in. drill bit, remove (2) rivets and weatherstrip (a) from bracket.
Remove two (2) weatherstrip bracket attaching screws and (b) bracket.
INSTALL
INSTALL QUARTER BELT OUTER WEATHERSTRIP.
1. Secure weatherstrip bracket to belt molding using two (2) (a) screws.
Position weatherstrip to bracket and secure using two (2) (b) 1/8 x .125 rivets.
NOTE: install rivets ONLY to rear and center weatherstrip mounting holes. INSTALL QUARTER BELT OUTER MOLDING (see 9-5).
2.
B-PILLAR MUCKET
REMOVE REMOVE QUARTER TRIM OUTER PANEL (see 5-5).
1.
REPOSITION QUARTER WINDOW AND GUIDE ASSEMBLY.
2. Using a pencil, mark location of three (3) quarter window (a) guide assembly nuts on inner body panels.
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.