Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
WEATHERSTRIPS AND RETAINERS
3-16
CENTER RAIL WEATHERSTRIP (cont'd)
While holding rear half of weatherstrip in retainer, pull the (d) front half up. Apply a continuous bead of adhesive (3M P/N 051135- (e) 08008 or equivalent), to exposed portion of retainer.
NOTE: Insure weatherstrip adhesive fills void at center of weatherstrip mounting surface.
Using a flat-bladed tool, install weatherstrip into center rail
(f) weatherstrip retainer. Repeat (d) through (f) to install rear half of center rail (g) weatherstrip. Check center rail weatherstrip fit. (h)
CENTER RAIL WEATHERSTRIP RETAINER
REMOVE
REMOVE CENTER RAIL WEATHERSTRIP (see Center Rail
4. Weatherstrip in this section).
MARK CENTER RAIL WEATHERSTRIP RETAINER-TO-
2.
CENTER RAIL LOCATION.
With a pencil, mark location of center rail weatherstrip retainer
washers on top side of center rail.
REMOVE CENTER RAIL WEATHERSTRIP RETAINER.
3.
Remove two (2) nuts with washers, and weatherstrip retainer.
CLEAN CENTER RAIL WEATHERSTRIP RETAINER.
4. Remove excess adhesive from center rail weatherstrip (a) retainer. Clean foam tape from retainer. (b)
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.