Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
3-8
WEATHERSTRIPS AND RETAINERS
FRONT HEADER WEATHERSTRIP
REMOVE
1. REMOVE WINDSHIELD HEADER MOLDING (See 2-4).
2.
REMOVE FRONT HEADER WEATHERSTRIP.
(a) Remove weatherstrip lower retainer (push pin).
(bo) Pull upward on weatherstrio end, and remove second retainer (push pin). (c) Repeat (a) and (b) for the other side of vehicle.
(d) Using a suitable release agent (3M P/N 051135-08971 or equivalent) and a flat-bladed tool, remove weatherstrip fre A-pillar retainer.
(e) Remove retainer (push pin) securing weatherstrip to top c A-pillar. (f) Using the above method, continue to remove weatherstrir from header retainer, and other side of vehicle.
CAUTION: Adhesive tape is applied between weatherstrip and windshield header. Do n tear or damage the weatherstrip during removal. If damaged, weatherstrip must be replaced.
INSTALL
1.
CLEAN FRONT WEATHERSTRIP RETAINERS.
(a) Remove excess adhesive from front header and both A- pillar weatherstrip retainers. (bo) Clean adhesive tape from weatherstrip and windshield header.
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.