Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Weatherstrips and Retainers - Nissan 240SX 1991-1992 Workshop Manual
Weatherstrips and Retainers
WEATHERSTRIPS AND RETAINERS
3-9
FRONT HEADER WEATHERSTRIP (cont'd)
2.
INSTALL FRONT HEADER WEATHERSTRIP TO WINDSHIELD
HEADER. (a) Install a new strip of 1/2 in. wide adhesive tape across windshield header. Tape should cover header molding stud holes. Do not pull backing from tape at this time.
(bo) Apply a continuous bead of adhesive (3M P/N 051 135- 08008 or equivalent) to front header weatherstrip retainer.
NOTE: Insure weatherstrip adhesive fills void at center of weatherstrip mounting surface.
(c) Secure front header weatherstrip end (corner) to top of A- pillar using retainer (push pin). (d) Repeat (c) on other side of vehicle.
(e) Starting at ends, then alternating from side-to-side working toward center, install weatherstrip to front header weatherstrip retainer using a flat-bladed tool.
(f) Latch top to header. (g) Lift header weatherstrip forward edge and remove adhesive tape backing. (h) Firmly press weatherstrip onto windshield header.
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.