Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - D Series07 Engine - L Series08 Engine - T Series09 Emission control10 Engine management system - MEMS11 Engine management system - PGMFi12 Engine management system - EDC13 Fuel delivery system14 Cooling system15 Cooling system - L Series16 Manifold & exhaust systems17 Clutch18 Manual gearbox - R6519 Manual gearbox - PG120 Automatic gearbox21 Drive shafts22 Steering23 Suspension24 Brakes25 Restraint systems26 Body27 Heating & ventilation28 Air conditioning29 Wipers & washers30 Electrical31 Instruments
Rover 400 Workshop Manual (1995-2000)26 · Body
26 · Body & interior

Front door outside handle

Make
Rover
Model
400 Workshop Manual
Year
1995–2000
Section
Doors › Front door outside handle
BodyFront door outside handle

FRONT DOOR OUTSIDE HANDLE

Service repair no - 76.58.07

Remove

NOTE: Raise door glass fully. Fit protection on door to avoid damage to paintwork.

  1. Remove door trim casing. See this section.
  2. Release plastic sheet from rear of door.
Front door outside handle – Release plastic sheet from rear of door.
  1. Release 4 clips private lock harness and multiplug to door. Disconnect multiplug.
Front door outside handle – Release 4 clips private lock harness and multiplug to door. Disconnect multiplug.
  1. Remove 2 bolts outside handle to door.
Front door outside handle – Remove 2 bolts outside handle to door.
  1. Release control rod and private lock rod from handle.
  2. Remove handle from door.

Parts & tools for this job For 1995 Rover 400

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.