Communication Systems - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Communication Systems - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Communication Systems
IN–19
INTRODUCTION – REPAIR INSTRUCTION

(2) Never work in a pit or near a pit as vaporized fuel will collect in those places. (b)
REMOVING AND INSTALLING FUEL SYSTEM
PARTS (1) Prepare a fire extinguisher before starting the operation. IN (2) To prevent static electricity, install a ground wire to the fuel changer, vehicle and fuel tank, and do not spray the surrounding area with water. Be careful when performing work in this area, as the work surface will become slippery. Do not clean up gasoline spills with water, as this may cause the gasoline to spread, and possibly create a fire hazard. (3) Avoid using electric motors, working lights and other electric equipment that can cause sparks or high temperatures. (4) Avoid using iron hammers as they may create sparks. (5) Dispose of fuel-contaminated cloth separately using a fire resistant container.
5.
REMOVAL AND INSTALLATION OF ENGINE INTAKE

PARTS (a) If any metal particles enter inlet system parts, they may damage the engine. (b) When removing and installing inlet system parts, cover the openings of the removed parts and engine openings. Use gummed tape or other suitable materials. (c) When installing inlet system parts, check that no metal particles have entered the engine or the D001563E01 installed parts.
6.
HANDLING OF HOSE CLAMPS
Spring Type Clamp (a) Before removing the hose, check the clamp position so that it can be reinstalled in the same position. (b) Replace any deformed or dented clamps with new ones. (c) When reusing a hose, attach the clamp on the clamp track portion of the hose. (d) For a spring type clamp, you may want to spread Clamp Track the tabs slightly after installation by pushing in the direction of the arrows as shown in the illustration. B107182E01

7.
FOR VEHICLES EQUIPPED WITH MOBILE

COMMUNICATION SYSTEMS
(a) Install the antenna as far away from the ECU and sensors of the vehicle electronic systems as possible. (b) Install an antenna feeder at least 20 cm (7.87 in.) away from the ECU and sensors of the vehicle electronic systems. For details about ECU and sensor locations, refer to the section of the applicable components. D020025E01
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.