System Parts - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- System Parts - Toyota Hilux Generation 7 2005-2010 Workshop Manual
System Parts
IN–18
INTRODUCTION – REPAIR INSTRUCTION
(i)
WIRE HARNESS AND CONNECTOR
(1) The SRS wire harness is integrated with the instrument panel wire harness assembly. All the connectors in the system are a standard yellow color. If the SRS wire harness becomes disconnected or the connector becomes broken, IN repair or replace it.
3.
ELECTRONIC CONTROL

(a)
REMOVAL AND INSTALLATION OF BATTERY
Negative (-) Cable TERMINAL
NOTICE: Certain systems need to be initialized after disconnecting and reconnecting the cable from Negative (-) the negative (-) battery terminal. Battery Terminal (1) Before performing electronic work, disconnect the cable from the negative (-) battery terminal to prevent component and wire damage caused by D033608E02 accidental short circuits. (2) When disconnecting the cable, turn the ignition switch off and the headlight dimmer switch OFF and loosen the cable nut completely. Perform these operations without twisting or prying the cable. Then disconnect the cable. (3) Clock settings, radio settings, audio system memory, DTCs and other data are erased when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable. (b)
HANDLING OF ELECTRONIC PARTS

(1) Do not open the cover or case of the ECU unless absolutely necessary. If the IC terminals are touched, the IC may be rendered inoperative by static electricity. (2) Do not pull the wires when disconnecting electronic connectors. Pull the connector. INCORRECT (3) Be careful not to drop electronic components, such as sensors or relays. If they are dropped on a hard surface, they should be replaced. D031751E01 (4) When cleaning the engine with steam, protect the electronic components, air filter and emission-related components from water. (5) Never use an impact wrench to remove or install temperature switches or temperature sensors. (6) When measuring the resistance of a wire connector, insert the tester probe carefully to prevent terminals from bending.
4.
REMOVAL AND INSTALLATION OF FUEL CONTROL
PARTS (a)
PLACE FOR REMOVING AND INSTALLING FUEL
SYSTEM PARTS
(1) Work in a location with good air ventilation that does not have welders, grinders, drills, electric motors, stoves, or any other ignition sources.
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.