General Notice - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- General Notice - Toyota Hilux Generation 7 2005-2010 Workshop Manual
General Notice
IN–11
INTRODUCTION – REPAIR INSTRUCTION
(1) Use the formula below to calculate special L2 L1 torque values for situations where SST or an extension tool is combined with a torque wrench. Formula: T' = L2 / (L1 + L2) * T IN

| T' | Reading of torque wrench {N*m (kgf*cm, ft.*lbf)} |
|---|---|
| T | Torque {N*m (kgf*cm, ft.*lbf)} |
| L1 | Length of SST or extension tool {cm (in.)} |
| L2 | Length of torque wrench {cm (in.)} |
D001201E01
NOTICE: If an extension tool or SST is combined with a torque wrench and the wrench is used to tighten to a torque specification in this manual, the actual torque will be excessive and parts will be damaged.
2.
FOR VEHICLES EQUIPPED WITH SRS AIRBAG AND
FRONT SEAT OUTER BELT ASSEMBLY WITH
PRETENSIONER The TOYOTA TACOMA is equipped with a Supplemental Restraint System (SRS).
CAUTION: Failure to carry out the service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing and lead to serious injury. Furthermore, if a mistake is made when servicing the SRS, it is possible that the SRS may fail to operate properly. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read the following section carefully. (a)
GENERAL NOTICE
(1) As malfunctions of the SRS are difficult to confirm, the Diagnostic Trouble Codes (DTCs) become the most important source of information when troubleshooting. When troubleshooting the SRS, always check the DTCs before disconnecting the battery.
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.