Check differential pressure sensor operation
- Make
- Fiat
- Model
- Croma Factory Service Manual
- Year
- 2005–2010
- Section
- Emission control system › Check differential pressure sensor operation
CHECK DIFFERENTIAL PRESSURE SENSOR OPERATION
| STEP | CHECK TO BE PERFORMED | RESOLUTION IF THE CHECK IS NOT OK |
|---|---|---|
| 1 | Check whether error P2455 - Differential pressure sensor - is present using the diagnostic equipment | Replace differential pressure sensor Op. 1080B82 PARTICULATE FILTER DIFFERENTIAL PRESSURE (D.P.F.) SENSOR - R R |
| 2 | Turn the ignition key OFF. Disconnect the wiring harness connector from the FAP differential pressure sensor. Turn the ignition key ON. Check that the voltage across pin 1 and 2 of the sensor See K187 FAP DIFFERENTIAL PRESSURE SENSOR is greater than 4.8 V. Move on to Step 4 | Move on to Step 3 |
| 3 | If faults are found, restore the wiring between the engine control unit and the downstream temperature sensor See E5070 PARTICLE FILTER SYSTEM Replace the wiring if necessary. The test can be considered over | Replace the engine management control unit |
| 4 | On the diagnostic tester, check whether the differential pressure sensor voltage parameter is between 4.8 and 5.2 V | Move on to Step 3 |
| 5 | Connect a shunt cable with a fuse between sensor Pin 3 See K187 FAP DIFFERENTIAL PRESSURE SENSOR and the earth. On the diagnostic tester, check whether the differential pressure sensor voltage parameter is less than 0.3 V | Move on to Step 3 |
| 6 | Replace differential pressure sensor Op. 1080B82 PARTICULATE FILTER DIFFERENTIAL PRESSURE (D.P.F.) SENSOR - R R |
Parts & tools for this job For 2005 Fiat Croma
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.