Operations

OPERATIONS

5040D11 - AIR CONDITIONER CONTROLS SUPPORT - R.R. OR REPLACE WITH INSTRUMENT DASHBOARD REMOVED

Removal

1. Unscrew the sheath fastening screw and withdraw the heater cock control cable.
2. Unscrew sheath fastening cable and withdraw the air distribution flap control cable.
3. Unscrew the sheath fastening screw and withdraw the air intake/recirculation flap control cable.
4. Disconnect the climate control air fan control electrical connection

5. Take out the switch control group lighting bulb holder.
6. Separate the air conditioner controls support from the bracket and remove.

Refitting

• Assemble the air conditioner controls support on the air conditioner box bracket.
• Insert the switch control group lighting bulb holders.
• Connect the climate control air fan control electrical connections
• Connect the air intake/recirculation flap control cable.
• Connect the air distribution flap control cable.

Note: After connecting the cables for the air intake/recirculation and air distribution flaps control, check that with the respective knobs at end of stroke the flaps shut off the air passage completely.

• Connect the heater cock control cable.

Note: After connecting the cable of the heater cable control, check that with the knob on cold air and maximum air heating the heater cock is fully closed or fully open respectively.

5040D28 - BULB/S FOR CLIMATE CONTROL SYMBOLS LIGHTING - R.R.

Removal

• Open the engine compartment.
• Disconnect the negative (-) battery terminal.

1. Take out the air fan control knob.
2. Unscrew the fastening screws (2a) of the switch control group (2b).

1. Remove the switch control group.

X Withdraw the switch control group from the lower part to release the upper securing tabs.

(Cont.d.)