Refitting

• Remove the front supplementary wheel housings (see Op. 7055B42 SUPPLEMENTARY WHEEL HOUSING (one) - R+R).
• Follow Op. 7055B10 FRONT BUMPER - R+R.

1. Unscrew the screws fastening the pipe of the compressor /condenser and separate it from the condenser.

Close the disconnected pipe fitting with sealing plugs to prevent moisture and impurities entering the system.

• Lower the vehicle.
• Take off the compressor pipe/condenser from the bracket on the engine.
• Raise the vehicle.

1. Unscrew the compressor pipe/condenser screw fastening to the compressor.

Close the disconnected pipe fitting with sealing plugs to prevent moisture and impurities entering the system.

• Lower the vehicle.
• Remove the compressor pipe/condenser from the engine compartment.

Only leave the air conditioner cooling circuit components disconnected for the time strictly necessary to carry out the intervention.

Refitting

At every disassembly replace the O-Rings of the pipe fittings. Only use green O-Rings, compatible with the coolant R134a. Lubricate the fitting threads with anti-freeze oil

• Refit the compressor pipe/condenser in the engine compartment.
• Join the compressor pipe/condenser to the compressor and tighten the screw to correct torque

• Fit the compressor pipe/condenser in the support bracket on the engine.
• Raise the vehicle.
• Join the compressor pipe/condenser to the compressor and tighten the screw to correct torque

• Complete with Op. 7055B10 FRONT BUMPER - R+R.
• Assemble the front supplementary wheel housings (see Op. 7055B42 SUPPLEMENTARY WHEEL HOUSING (one) - R+R).
• Assemble the engine compartment protection and fasten with its screws.
• Complete with Op. 4450B12 Front WHEELS (two) - R.R.
• Lower the vehicle.
• Complete with Op. 5040A10 Air conditioner cooling CIRCUIT - Dehydration and Recharging.
• Connect the negative (-) battery terminal

• Remove the body protection cover.
• Close the engine compartment.
• Remove the vehicle from the shop jack.