Refitting

(Cont. Op. 5580C18)

Untriggered airbag modules after removal must be immediately stored in a specific, locked cabinet with the cover facing upwards.

Only reconnect the battery after completing the assembly.

NOTE After the intervention, check system operation with specific diagnostic tools.

Refitting

Inspect the removed parts with care. Check there are no faults such as dents, breakages or cracks which could compromise airbag operation.

• Position the module on the steering wheel and screw the four fastening screws.
• Refit the two tabs (next to the steering wheel) covering the unit screws.
• Reconnect the positive and negative battery cables.

5580C22 - AIRBAG MODULE (PASSENGER SIDE) - R.R.

Interventions on airbag system components must be performed by specifically trained staff, STRICTLY attaining to the following safety precautions. For removal and replacement, use polyethylene gloves and goggles. Always turn the ignition key to STOP, remove it and disconnect and insulate the positive and negative battery cables with care when removing/refitting the ECU.

Wait for 10 minutes before proceeding.

Never use naked flames near the ECU and system components.
Single system components cannot be repaired. Replace them entirely.

Attain to all the prescribed rules (see 5580C - Precautions).

Removal

1. Remove the two tabs and remove the two screws fastening the airbag module to the dashboard.

2. Extract the airbag module and disconnect the electric connection. Be careful not to damage the wire.

Untriggered airbag modules after removal must be immediately stored in a specific, locked cabinet.

Only reconnect the battery after completing the assembly.

(Cont.d.)