Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)10 · 55 Electrical equipment
10 · Electrical

Refitting

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Special accessories › Refitting
55 Electrical equipmentRefitting

(Op. 5580E22 continued)

  1. Disconnect the volumetric sensor electric connection.
  2. Remove the volumetric sensor and keep it.
  3. If required, lift and remove the volumetric sensor retaining pad.
Diagram showing the volumetric sensor assembly with callout numbers 1, 2, and 3 indicating the electric connection, sensor, and retaining pad respectively.

Refitting

  • Check that the volumetric sensor is not damaged.
  • If removed, fit the volumetric sensor retaining pad.
  • Fit the volumetric sensor and connect the electric connections.
  • Connect the volumetric sensor support electric connection.
  • Reposition the volumetric sensor support and fasten screws.
  • Complete with Op. 7040E10 - FRONT CEILING LIGHT - R.R.
  • Check system operation with an Examiner or other diagnostic tool.

5580E26 - BONNET/BOOT ALARM SWITCH - R.R. FOLLOWING CHECKS TO ELECTRIC CIRCUIT

Removal

  1. Open the boot and loosen the electric switch-contact unit fastening screw.
  2. Disconnect the electric connections.
NameConnector
Boot rear contact unitD85
  1. Take the electric switch-contact unit.
Diagram showing the electric switch-contact unit being removed from the boot area, with callout numbers 1 (fastening screw), 2 (electric connection), and 3 (unit body). A lightning bolt warning symbol is present near the connection.

Refitting

  • Check the electric switch-contact unit is not damaged.
  • Connect the electric switch-contact unit connections.
  • Reposition the electric switch-contact unit and fasten screw.
  • Check system operation with an Examiner or other diagnostic tool.

5580E28 - BOOT ALARM SWITCH - R.R. A FOLLOWING CHECKS TO ELECTRIC CIRCUIT

Removal

  • Open bonnet and secure it.
  1. Disconnect the alarm switch electric connection.
DescriptionConnector
Bonnet switch
  1. Lift and remove the switch.
Diagram showing the removal of the alarm switch from the bonnet hinge area, with callout numbers 1 (switch) and 2 (connection/wire). A lightning bolt warning symbol is present near the switch.

(Cont..)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.