landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Manifold - coolant|Page 380 > < Coupling unit - viscous fan
Page 315
background image

COOLING SYSTEM - V8

26-2-4

REPAIRS

8. Release cowl from mountings and remove cowl 

and fan assembly.

9. Place viscous coupling and fan to work bench.

NOTE: Do not carry out further dismantling if 
component is removed for access only.

10. Remove 4 bolts and remove coupling from fan.

Refit

1. Clean coupling and fan mating faces.
2. Fit viscous coupling to fan and tighten 4 bolts to 

10 Nm (7 lbf.ft).

3. Carefully fit fan and cowl assembly, secure the 

cowl to mountings.

4. Fit fan assembly to coolant pump. Using LRT-

12-214 and LRT-12-215 tighten viscous 
coupling lock nut to 45 Nm (33 lbf.ft).

5. Fit cooling fan harness and multiplug to fan 

cowl.

6. Fit screw securing fan cowl to radiator.
7. Secure 3 coolant hoses to clips on fan cowl.
8. Fit undertray.

 

 + 

 EXTERIOR FITTINGS, REPAIRS, 

Undertray - front.

9. Connect battery earth lead.

Manifold - coolant 

$% 26.30.64 

Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 

 + 

 GENERAL INFORMATION, Electrical 

Precautions.

Remove

1. Position vehicle on lift.
2. Disconnect battery earth lead.
3. Drain coolant.

 

 + 

 COOLING SYSTEM - V8, 

ADJUSTMENTS, Coolant - drain, flush & 
refill.

4. Remove air intake plenum.

 

 + 

 HEATING AND VENTILATION, 

REPAIRS, Plenum - air intake.

5. Remove throttle body.

 

 + 

 ENGINE MANAGEMENT SYSTEM - 

V8, REPAIRS, Throttle body.

6. Remove bolt securing engine harness to 

coolant manifold.

7. Disconnect heater pipes from coolant manifold.
8. Release harness from 2 clips on coolant 

manifold.

M26 0887

Manifold - coolant|Page 380 > < Coupling unit - viscous fan