L322 Range Rover Service Procedures
COOLING SYSTEM - V8
26-2-6
REPAIRS
Pipe(s) - coolant pump to coolant
manifold
$% 26.31.25
Remove
1. Drain coolant.
ADJUSTMENTS, Coolant - drain, flush &
refill.
2. Remove inlet manifold.
- V8, REPAIRS, Gasket(s) - inlet manifold.
3. Remove bolt securing engine harness to
coolant manifold.
4. Release harness from 2 clips on coolant
manifold.
5. Release transfer gearbox breather pipe from
clip.
6. Remove 6 bolts securing coolant manifold to
cylinder heads.
7. Secure coolant pipes and reposition coolant
manifold.
8. Remove and discard coolant manifold gaskets.
9. Remove 2 coolant pipes from coolant pump.
10. Discard 'O' rings.
Refit
1. Clean gasket mating faces.
2. Fit new 'O' rings to coolant manifold.
3. Fit coolant pipes to the coolant pump.
4. Position new gaskets and coolant manifold to
cylinder heads, fit bolts and tighten to 10 Nm (7
lbf.ft).
5. Fit transfer gearbox breather pipe to clip.
6. Fit harness into clips.
7. Fit bolt securing engine harness to coolant
manifold and tighten to 10 Nm (7 lbf.ft).
8. Fit inlet manifold.
- V8, REPAIRS, Gasket(s) - inlet manifold.
9. Refill cooling system.