L322 Range Rover Service Procedures
HEATING AND VENTILATION
80-16
REPAIRS
Fuel pump - Fuel Burning Heater (FBH)
Td6
$% 80.40.40
Remove
1. Disconnect battery earth lead.
2. Raise rear of vehicle, one side.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
3. Remove RH rear road wheel.
4. Release pump from rubber mounting.
5. Disconnect multiplug from fuel pump.
6. Release clips and remove fuel pipes from fuel
pump.
CAUTION: Before disconnecting or
removing components, ensure the
immediate area around joint faces and
connections are clean. Plug open
connections to prevent contamination.
7. Recover pump from vehicle and remove rubber
mounting.
Refit
1. Clean fuel hose connections.
2. Fit rubber mounting to pump.
3. Position fuel pipes to pump and secure with
clips.
4. Connect multiplug to fuel pump.
5. Fit pump assembly to mounting bracket.
6. Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
7. Lower vehicle.
8. Connect battery earth lead.
M80 0571