L322 Range Rover Service Procedures
REAR SUSPENSION
64-4
REPAIRS
13. Remove Allen screw securing hand brake
cable bracket.
14. Remove bolt securing handbrake cable to
backplate.
15. Release handbrake cable from backplate.
16. Fit centre screw LRT-60-030/3 to LRT-60-030/
1 and fit to hub with spacer LRT-60-030/2.
Secure with nuts LRT-60-030/5.
17. Tighten centre screw to press drive shaft from
flange.
18. Remove tools.
19. Reference mark eccentric in relationship to
upper arm.
20. Remove and discard nut and bolt securing hub
to upper arm. Release hub from arm.
21. Remove and discard nut and bolt securing
lower arm to hub.
22. Remove hub assembly.
Refit
1. Clean drive shaft and flange splines.
2. Lightly lubricate splines.
3. Clean hub and mating faces on upper and
lower arms.
4. Position hub assembly, fit new lower bolt and
locate drive shaft in hub.
5. Align hub to upper arm, fit new bolt, align
eccentric to reference mark and lightly tighten.
6. Tighten bolt securing lower arm to hub to 250
Nm (184 lbf.ft).