L322 Range Rover Service Procedures
REAR SUSPENSION
REPAIRS
64-17
Bushes - lower arm - rear
$% 64.35.17
The bushes must be replaced as a pair, LH and RH
sides.
Remove
1. Remove lower arms.
2. Remove bush using LRT-64-028/1 with LRT-
64-028/2 and LRT-64-028/3 in direction shown.
3. Repeat procedure for other side.
Refit
1. Ensure bush and bush location in lower arm is
clean.
2. Fit bush using LRT-64-028/4 with LRT-64-028/
2 and LRT-64-028/3 in direction shown.
3. Repeat procedure for other side.
4. Fit lower arms.
Link - anti roll bar
$% 64.35.24
Remove
1. Raise rear of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel.
3. Remove nut securing anti-roll bar link to anti-
roll bar.
CAUTION: Use an open ended spanner on
flats provided to prevent ball joint rotating.
4. Remove nut securing anti-roll bar link to lower
arm.
5. Release link from anti-roll bar.
6. Remove anti-roll bar link and collect washer
fitted to lower ball joint.
CAUTION: Note position of washer for refit.
Refit
1. Fit washer to ball joint, fit anti-roll bar link, fit
nuts and tighten to 100 Nm (74 lbf.ft).
CAUTION: The washer is hardened and
must be fitted in the correct position.
2. Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
3. Remove stands and lower vehicle.