Front output housing (page 2 of 3)
- Make
- Land Rover
- Model
- Gearboxes LT230 Transfer Box
- Section
- OVERHAUL
TRANSFER BOX
8
OVERHAUL
11. Position propeller shaft flange holding tool
LRT-51-003 to output shaft flange.
12. Remove and discard self-locking nut.
13. Remove and discard steel and felt washers.
14. Remove output shaft flange together with mud
shield.
NOTE: A replacement output flange will be
supplied together with new mud shield
and output shaft oil seal.
15. Using a mallet, drive output shaft out of front
output housing.
NOTE: If it is necessary to use a hand
press to remove output shaft, position
thrust button LRT-370-11/2 between shaft
and press mandrel.
16. Noting its fitted position, remove dog clutch
from output shaft.
17. Noting its fitted position, remove bearing
spacer from output shaft.
18. Taking care not to damage front output
housing, remove and discard output shaft oil
seal.
Parts & tools for this job For Land Rover Gearboxes
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Land Rover Gearboxes
As an Amazon Associate we earn from qualifying purchases.