Range Rover P38
STEERING
13
REPAIR
POWER STEERING PUMP - V8 - FROM 99MY
Service repair no - 57.20.14
Remove
CAUTION: Seal all disconnected pipes and
ports to prevent ingress of dirt.
1. Remove alternator drive belt.
See
ELECTRICAL, Repair.
2. Position suitable container below vehicle to
catch oil spillage.
3. Remove banjo bolt securing high pressure pipe
to pump. Remove and discard sealing washers.
4. Remove and discard clip securing feed hose to
pump and disconnect hose.
5. Plug open connections on pump, high pressure
pipe and feed hose.
6. Remove 2 bolts securing pump to mounting
bracket and remove pump.
Refit
7. Clean pump and mounting bracket mating faces,
dowel and dowel holes.
8. Fit pump to mounting bracket and tighten bolts to
25 Nm (18 lbf.ft).
9. Connect feed hose to pump and secure with
new clip.
10. Clean high pressure pipe and banjo bolt.
11. Connect high pressure pipe to pump using new
sealing washers. Tighten banjo bolt to
25 Nm
(18 lbf.ft).
12. Fit alternator drive belt.
See ELECTRICAL,
Repair.
13. Bleed power steering system.
See this section.