Range Rover P38
STEERING
15
REPAIR
11. Remove steering pump. Plug all hoses and
connections.
Refit
12. Remove plugs from hoses and connections.
13. Using new sealing washers, secure high
pressure pipe to steering pump with banjo bolt.
Tighten to
30 Nm (22 lbf.ft)
14. Connect low pressure hose to pump. Secure
with new clip.
15. Position steering pump on bracket. Secure with
bolts.
16. Position pulley on steering pump. Fit bolts, finger
tight.
17. Lever tensioner pulley to slack position. Engage
belt over power steering pump pulley.
18. Tighten steering pump pulley bolts.
19. Lower lift.
20. Reconnect battery negative lead.
21. Fill power steering reservoir.
See
LUBRICANTS, FLUIDS AND CAPACITIES,
Information.
22. Bleed steering system.
See this section.
STEERING WHEEL
Service repair no - 57.60.01
Remove
1. Remove steering wheel pad.
See this section.
2. Vehicles with SRS: Remove drivers air bag
module.
See SUPPLEMENTARY RESTRAINT
SYSTEM, Repair.
3. Disconnect steering wheel switch multiplug.
4. Release harnesses from clip.
5. Remove bolt securing steering wheel to column.
6. Remove steering wheel.
CAUTION: Ensure that air bag module and
steering wheel switch harnesses are
released during steering wheel removal.