Range Rover P38
57
STEERING
NEW RANGE ROVER
16
REPAIR
Disassemble
7. Remove 2 screws securing multiplug to horn
unit.
8. Remove 3 screws securing printed circuit to horn
unit.
WARNING: Take great care when removing
the 3 screws securing the printed circuit to
horn unit. The screws are non replaceable
and other fixings must not be used. If the screws
are damaged during removal, the steering wheel
must be renewed.
9. Lift 2 clips securing each switch pack. Remove
switch packs and printed circuit assembly.
Assemble
10. Position switch pack assembly. Engage switches
to steering wheel.
CAUTION: Ensure switches are correctly
engaged.
11. Secure multiplug and printed circuit with screws.
Refit
12. Route harnesses through steering wheel
aperture.
13. Position steering wheel. Secure with bolt.
Tighten to
33 Nm (24 lbf.ft)
14. Connect steering wheel switch multiplug.
15. Secure harnesses in clip.
16. Fit steering wheel pad.
See this section.
17. Vehicles with SRS: Fit drivers air bag module.
See SUPPLEMENTARY RESTRAINT SYSTEM,
Repair.