Range Rover P38 Power Steering Pump Repair V8 - Up to 99MY
57
STEERING
NEW RANGE ROVER
12
REPAIR
POWER STEERING PUMP - V8 - UP TO 99MY
Service repair no - 57.20.14
Remove
CAUTION: Seal all disconnected pipes and
ports to prevent ingress of dirt.
1. Remove alternator drive belt.
See
ELECTRICAL, Repair.
2. Remove 3 bolts securing pump pulley. Remove
pulley.
3. Position container to catch fluid.
4. Release clip securing return hose to pump.
Release hose.
5. Disconnect high pressure pipe union from pump.
6. Remove 4 bolts securing pump and compressor
mounting bracket to engine.
7. Remove 3 bolts securing mounting plate to
pump. Remove plate.
8. Remove pump assembly.
9. Remove 2 screws securing engine lifting bracket
to pump.
Refit
10. Ensure mating faces are clean.
11. Position lifting bracket to pump. Secure with
screws. Tighten to
18 Nm (13 lbf.ft)
12. Position mounting plate to pump. Loosely fit
bolts.
13. Align pump assembly and compressor mounting
bracket to engine. Secure with bolts. Tighten to
40 Nm (30 lbf.ft)
14. Tighten pump to mounting bolts to
18 Nm
(13 lbf.ft)
15. Connect high pressure pipe to pump. Tighten to
16 Nm (12 lbf.ft)
16. Position return hose to pump. Secure with clip.
17. Position pulley to pump. Secure with bolts.
Tighten to
25 Nm (18 lbf.ft)
18. Secure coolant hose to lifting bracket.
19. Fit drive belt.
See ELECTRICAL, Repair.
20. Reconnect battery negative lead.
21. Bleed power steering system.
See this section.