Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Adjustment shim assembly note (page 3 of 5)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential
Driveline and axlesAdjustment shim assembly note · page 3 of 5
DRIVELINE/AXLES – Differential – figure
Fig. 43: Measuring Width Of Differential Gear Case Component In Differential Carrier
Courtesy of MAZDA MOTORS CORP.
  1. The combined thickness of the left and right adjustment shims is obtained by the following formula.

Shim thickness (mm {in}) =B-A+ (0.01-0.03 {0.0004-0.0118 in})

  1. If the combined thickness of the previously assembled adjustment shims is equal to the calculated thickness, use the shims as they are.
  2. If the combined thickness of the previously assembled adjustment shims is not equal to the calculated thickness, or if the adjustment shims have to be replaced, select two appropriate adjustment shims from the table below.

ADJUSTMENT SHIM TABLE

Identification markThickness (mm {in})Identification markThickness (mm {in})
5505.50 {0.217}6056.05 {0.238}
5605.60 {0.220}6106.10 {0.240}
5655.65 {0.222}6156.15 {0.242}
5705.70 {0.224}6206.20 {0.244}
5755.75 {0.226}6256.25 {0.246}
5805.80 {0.228}6306.30 {0.248}
5855.85 {0.230}6356.35 {0.250}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.