Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)05 · Driveline and axles
05 · Transmission

Adjustment shim assembly note (page 4 of 5)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Differential
Driveline and axlesAdjustment shim assembly note · page 4 of 5
5905.90 {0.232}6406.40 {0.252}
5955.95 {0.234}6506.50 {0.256}
6006.00 {0.236}--

NOTE: If the adjustment shims are to be reused, assemble the left and right shims that were identified during disassembly.

When assembling the side bearing races, do not mix the left and right side bearings that were identified during disassembly.

  1. Assemble the differential gear case component and the side bearing race to the differential carrier.
  2. Tap the selected adjustment shim between the differential carrier and the side bearing race with a plastic hammer as shown in Fig. 44 .
DRIVELINE/AXLES – Differential – figure
Fig. 44: Tapping Selected Adjustment Shim Between Differential Carrier & Side Bearing Race
With Plastic Hammer
Courtesy of MAZDA MOTORS CORP.
  1. Align the bearing cap alignment marks, assemble the bearing cap, and then temporarily tighten the bolts.
  2. Install the dial gauge with the measuring probe of the dial gauge attached perpendicularly to the end of one of the ring gear teeth.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.