Workshop Manuals Factory service & repair Rover
Rover 200 Workshop Manual (1995-1999)05 · Engine - K8
05 · Engine

Camshaft rear oil seal

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Repairs › Camshaft rear oil seal
Engine - K8Camshaft rear oil seal
  1. Using tool 12-182 hold camshaft gear against rotation and tighten centre bolt to: M8 Bolt - 35 Nm M10 Bolt - 65 Nm
  2. Check camshaft gear timing mark alignment.
  3. Fit new camshaft timing belt. See this section.

CAMSHAFT REAR OIL SEAL

Service repair no - 12.13.06

Remove

  1. Disconnect battery earth lead.
  2. Remove air cleaner assembly. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
  3. Remove distributor cap. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
Camshaft rear oil seal – Remove distributor cap. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
  1. Screw tool 18G 1299A into camshaft rear oil seal.
  2. Tighten centre bolt, tool 18G 1299A-1, to remove seal.
  3. Remove camshaft oil seal.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.