Original page (page 2 of 2)

A   Reservoir hose
B     Reservoir cap
C     Reservoir
D     Tube joint
E     Washer
F     Master cylinder body
G     Cotter pin
H     Push rod
I     Piston assembly
J     Yoke
K     Pedal pin
L     Dust seal
M     Circlip
N     Stopper
O     Apply Rubber grease

CAUTION: Do not allow brake fluid to contact paint finished surfaces as paint may be damaged. If spilled, remove fluid and clean area with clean warm water.

• Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
• Before reassembling, check that all parts are free of dust and other foreign particles.
• Check master cylinder wall for wear and scoring.
• Check piston assembly for wear and damage.
• Check stopper for damage and bending.
• Replace cotter pins and tube washers.
• Make sure no dirt or other foreign matter is allowed to contaminate the brake fluid.
• Do not mix different brands of brake fluid as they may not be compatible.
• Do not use the drained fluid. Use only clean DOT 3 or 4 brake fluid.

Note: LHD type is shown. RHD type is similar.