Inspect Camshafts - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Inspect Camshafts - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Inspect Camshafts
EM–214
1GR-FE ENGINE MECHANICAL – ENGINE UNIT

(b) Using several steps, uniformly loosen and remove the 16 main bearing cap bolts in the sequence shown in the illustration. 4 12 8 6 16 11 3 14 15 7 2 10 13 5 9 1

A076049E01 (c) Using a screwdriver, pry out the main bearing caps. Remove the 4 main bearing caps and lower bearings.

NOTICE:
• Pull up the main bearing cap by turning it to the right and left little by little. EM
• Be careful not to damage the joint surfaces of the cylinder block and the main bearing cap.
46. REMOVE CRANKSHAFT THRUST WASHER SET
47. REMOVE CRANKSHAFT BEARING

Joint Surface A121032E01
48. REMOVE NO.1 SUB-ASSEMBLY OIL NOZZLE

(a) Using a 5 mm socket hexagon wrench, remove the 3 oil nozzles.
A076051E01 INSPECTION

1.
INSPECT CAMSHAFTS
(a) Inspect the camshaft for runout. (1) Place the camshaft on V-blocks. (2) Using a dial indicator, measure the circle runout at the center journal. Maximum runout:
0.06 mm (0.0024 in.) If the circle runout is greater than the A005912E01 maximum, replace the camshaft.
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.