Inspect Valve - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Inspect Valve - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Inspect Valve
EM–222
1GR-FE ENGINE MECHANICAL – ENGINE UNIT

18. CLEAN VALVE

(a) Using a gasket scraper, chip off any carbon from the valve head. (b) Using a wire brush, thoroughly clean the valve.
EM00580E01
19. INSPECT VALVE

(a) Inspect valve stem diameter. (1) Using a micrometer, measure the diameter of the valve stem. Valve stem diameter EM
| Intake Exhaust | 5.470 to 5.485 mm (0.2154 to 0.2159 in.) 5.465 to 5.480 mm (0.2152 to 0.2158 in.) |
|---|---|
| Exhaust | 5.465 to 5.480 mm (0.2152 to 0.2158 in.) |
A032770E01 (b) Inspect valve face angle. (1) Grind the valve enough to remove any pits and carbon. (2) Check that the valve is ground to the correct valve face angle. Valve face angle:

45.5°
45.5 °
A075611E03 (c) Inspect valve head margin thickness. (1) Using vernier calipers, check the valve head margin thickness. Standard margin thickness:

1.0 mm (0.039 in.) Margin Minimum margin thickness: Thickness
0.5 mm (0.020 in.) If the margin thickness is less than the minimum, replace the valve. EM00181E02 (d) Inspect overall length. (1) Using vernier calipers, check the overall length. Standard overall length Overall Length

| Intake | 106.95 mm (4.2106 in.) |
|---|---|
| Exhaust | 105.80 mm (4.1654 in.) |
| Minimum overall length | |
| Intake | 106.70 mm (4.2008 in.) |
| Exhaust | 105.55 mm (4.1555 in.) |
EM02534E08
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.