Remove Valve - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Remove Valve - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Remove Valve
EM–210
1GR-FE ENGINE MECHANICAL – ENGINE UNIT

31. REMOVE NO.1 WATER OUTLET PIPE

(a) Separate the knock sensor wire. (b) Remove the 3 bolts, then remove the water outlet pipe.
G036807E01
32. REMOVE KNOCK CONTROL SENSOR

(a) Disconnect the knock sensor connectors. (b) Remove the 2 bolts, then remove the 2 knock sensors. EM
A076270E01
33. REMOVE REAR ENGINE OIL SEAL RETAINER

(a) Remove the 5 bolts and 2 nuts. Pry (b) Using a screwdriver, remove the oil seal retainer by prying between the oil seal retainer and crankshaft bearing cap.
A076247E02
34. REMOVE VALVE LIFTER

HINT: Arrange the valve lifter in the correct order.
A075601E01
35. REMOVE VALVE

HINT: SST Arrange the valves, inner compression springs, valve spring retainers and valve spring retainer rocks in the correct order. (a) Place the cylinder head on a wooden block. (b) Using SST, compress the inner compression spring and remove the 2 valve spring retainer rocks. SST 09202-70020 (09202-00010) Wooden Block (c) Remove the valve, inner compression spring and A075602E02 valve spring retainer.
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.