Remove Crankshaft - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- Remove Crankshaft - Toyota Hilux Generation 7 2005-2010 Workshop Manual
Remove Crankshaft
EM–213
1GR-FE ENGINE MECHANICAL – ENGINE UNIT

43. REMOVE WITH PISTON SUB-ASSEMBLY

80°C Gradually heat the piston to approximately 80°C (a) (176°F).
A076045E06 (b) Using a plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.

HINT:
• The piston and pin are a matched set.
• Arrange the pistons, pins, rings, connecting rods EM and bearings in the correct order.
A076046E01
44. INSPECT CRANKSHAFT THRUST CLEARANCE

(a) Using a dial indicator, measure the thrust clearance while prying the crankshaft back and forth with a screwdriver. Standard thrust clearance:
0.04 to 0.24 mm (0.0016 to 0.0094 in.) Maximum thrust clearance:
0.30 mm (0.0118 in.) If the thrust clearance is greater than the maximum, replace the pair of the thrust washers or crankshaft. A076047E01
HINT: Thrust washer thickness:
1.93 to 1.98 mm (0.0760 to 0.0780 in.)
45. REMOVE CRANKSHAFT

(a) Using several steps, uniformly loosen and remove 5 the 8 main bearing cap bolts and seal washers in 8 the sequence shown in the illustration. 7 2 3 6 4 1 A076048E01
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.