F7:PROGRAMMING - Note

Table 7, F7: Programming

 

Note:

 

If a new control unit or a control unit from another vehicle is installed in a vehicle, the control unit must be re - programmed.

Observe the notes listed below carefully, since otherwise Motronic, automatic transmission and ABS - 2SH are not properly matched:

 

When asked whether the correct Motronic control unit is installed, proceed according to the following information or the latest "Technical Information Bulletins":

The following control unit is currently used in Omega - B vehicles with X 25 XE engine:

Opel Part No.:          90457097

Alpha Code:             PR

 

The following control unit is currently used in Omega - B vehicles with X 30 XE engine:

Opel Part No.:          90457098

Alpha Code:             PS

 

When asked whether the correct AT control unit is installed, proceed according to the following information or the latest "Technical Information Bulletins":

The following control unit is currently used in Omega - B vehicles with X 20 SE / X 20 XEV / X 25 XE / X 30 XE engine:

Opel Part No.           96017168

Alpha Code:             KT

 

The following control unit is currently used in Omega - B vehicles with 25 DT engine:

Opel Part No.:          96016632

Alpha Code:             HU

 

When asked whether the correct ABS - 2SH (with TC) control unit is installed, proceed according to the following information or the latest "Technical Information Bulletin":

At present, the OMEGA - B with the X 25 XE / X 30 XE engine is equipped with the following control unit:

Opel Part No.:          90447587

Alpha Code:             XD

 

Important:

In the most unfavourable circumstances, incorrect programming can lead to drivability problems (jerking, driving off problems, etc. ).