Engine RPM SENSOR - R.R.

Operation 1060G20 · Pressure pump electric control

1.9 JTD 8V

Removing

Place the car on a ramp.

Disconnect the battery negative terminal.

- 7055B54 under-engine guard - r r

1. Disconnect the electrical connection for the rpm sensor.

2. Undo bolts (2a) and remove rpm and timing sensor (2b).

Refitting

Fit the rpm and timing sensor and secure it using the retaining bolt.

Connect the electrical connection

- 7055B54 under-engine guard - r r

Connect the battery negative terminal.

Remove the car from the lift.

1.9 JTD 16V

Removing

Position the vehicle on the ramp.

Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

Proceed with removal - 7055B54 under-engine guard - r r.

1. Disconnect the electrical connection for the rpm sensor.

2. Undo the bolt (2a) and remove the engine rpm sensor (2b).

Refitting

Place the engine rpm sensor back in its housing and fix it using the bolt.

Connect the electrical connection for the rpm sensor.

Proceed with refitting - 7055B54 under-engine guard - r r.

Connect the negative (-) battery terminal.

Remove the car from the ramps.